PORON is basically about two meters long when it leaves the factory. At present, some traders in the market pretend to be Rogers agents, and then quote very low prices to attract customers. At present, there are only two Rogers authorized agents in the mainland market. So there are two reasons why we can do it. First, cut the customer's meters on the goods, and second, the source of goods is not correct. This brings loss and inconvenience to the die-cutting manufacturers. Here, I suggest that customers using Rogers materials can make the following requirements for suppliers. First, they should be original. (the original packaging is not moved. First, it can be seen from the box. Please note that some people unpack the box from the bottom. Second, it can be seen from the tensile film that the moved tensile film can not be wrapped tightly and evenly). Second, the lot number on Rogers's shipping label should be left, because if there is a problem, you can inquire. If there is a problem in quality, you can also ask for compensation. At the same time, you can also find out the material The authenticity of the material. If you don't buy from the agent and the price is low, please pay attention to the problem of less meters. You can also judge by asking if your supplier can sell bulk materials. You can ask to buy more than half to judge. Because some traders cut several square meters or meters on the goods. They can sell a small amount, but they can't sell half. If your supplier says you can sell bulk materials. But when you can't sell half of it to you, please pay attention to whether your supplier has less meters for the whole material. In fact, when the number of meters is less, the square price you purchase is higher. Because the materials delivered by Rogers are basically more than two meters, there is no problem of less meters.
Thickness is a problem encountered by die-cutting plants in practice. At present, it is mainly in 4701-30 and 4701-40 without pet. The main reason is that the material near the pipe core will be thinner. When you encounter this situation, you can deal with it in the following ways to reduce the loss. The first is to stop slitting, the second is to keep the label on the pipe core (but the label should have lot number). The third is to measure whether the slitting quantity reaches the length marked by Rogers. If it is not enough, you can ask your supplier to compensate you for the quantity.
The problems encountered by our company in Rogers materials are basically the following treatment methods
1、 If the customer's response is less meters, our company will ask for the weight. (because our company has never had the problem of less meters, especially when the customer buys only a little more bulk materials.) because the customer's method of measuring meters will be different, there will be errors. If the weight is not right, our company will send someone to measure it. Our commitment is to make up for ten less, but only more.
2、 As for the treatment method of thickness, I ask the customer to send the defects considered by the customer to our company, and our company will measure them. If they are within the tolerance, our company will issue Rogers's certificate. If the tolerance is exceeded, our company will make up the amount returned by the customer.
At ordinary times, there are still some wrinkle problems, and our company will be close to possible to prevent customers from losing.